*Note, invalid miner addresses specified in scripts will authorize as zs1ufhz7jn3v4fya5vw5cdj76gm8prdwrrf3mwwmzkwzcw45s6zz7a0kx987asg75wnhkaqktx3j6l
If you find you're mining on the above address, please check your miner setup for a typo or mistake in your miner configuration!
Miner Software Config Generator

Available Mining Servers
Algorithm Verushash V2.1
Server/Port na.luckpool.net eu.luckpool.net ap.luckpool.net
CPU 3960 3960 3960
SSL 3958 3958 3958
Username Use an anonymous (t-addr) that starts with "R" or a Sapling (z-addr) that starts with "zs1"
Worker You may provider worker name as follows: USERNAME.WORKER
Password Simply use 'X' as password. See below for advanced parameters.
Advanced Password Parameters

Use a comma to separate multiple password field parameters. For example; 'd=16,xn=1,hybrid'.

Custom Desired Difficulty (d)

You may provide a desired difficulty as 'd=16384'. This sets the minimum difficulty your miner will receive. It is possible to make your difficulty static by appending a S; for example, 'd=16384S'.

* Note, 'd=1' equals a difficulty of 8192. 'd=2' equals a difficulty of 16384.

Hybrid Solo Mining (hybrid)

Simply place 'hybrid' in your password field to enable Hybrid Solo Mining*.
You may run multiple workers in hybrid mode and multiple workers in regular pool mode.
* HYBRID worker names should not match pool worker names to prevent loss of pool worker rewards from hybrid blocks.

Time Rolling (t)

You may provide a fixed time rolling offset using 't=1' where 1 is in seconds with a max of 120. Time Rolling will not exceed 60 seconds into the future. *Mining software is allowed to time roll no more than 600 seconds, as per consensus. Shares submitted with time values out of range will result in 'time too new' or 'time too old' rejects.

XtraNonce Subscribe (xn) XNSUB

You may control the interval at which your nonce is rolled using 'xn=1' where 1 is in minutes. Default is 60 minutes.
*See your miner hardware/software for details on enabling XtraNonce subscribe (#xnsub)
* XNFORCE It is possible to force xtranonce subscribe by appending an F; for example, 'xn=5F'.