If you find you're mining on the above address, please check your miner setup for a typo or mistake in your miner configuration!
|Username||Use an anonymous (t-addr) that starts with "t1" or a Sapling (z-addr) that starts with "zs1"|
|Worker||You may provider worker name as follows: USERNAME.WORKER|
|Password||Simply use 'X' as password. See below for advanced parameters.|
Use a comma to separate multiple password field parameters. For example; 'd=16,xn=1,hybrid'.
| Custom Desired Difficulty (d) |
You may provide a desired difficulty as 'd=1'. This sets the minimum difficulty your miner will receive. It is possible to make your difficulty static by appending a S; for example, 'd=1S'.
* Note, 'd=1' equals a difficulty of 8192. 'd=2' equals a difficulty of 16384.
| Hybrid Solo Mining (hybrid) |
Simply place 'hybrid' in your password field to enable Hybrid Solo Mining*.
| Time Rolling (t) |
You may provide a fixed time rolling offset using 't=1' where 1 is in seconds with a max of 120. Time Rolling will not exceed 60 seconds into the future. *Mining software is allowed to time roll no more than 600 seconds, as per consensus. Shares submitted with time values out of range will result in 'time too new' or 'time too old' rejects.
| XtraNonce Subscribe (xn) XNSUB |
You may control the interval at which your nonce is rolled using 'xn=1' where 1 is in minutes. Default is 60 minutes.